Dissent off road / CA Tuned / Rago / Victory 4x4 / Expedition one are just a few of the other fairly well known bumpers that don't appear to be problematic with sensor integration.
The ARB Summit bar installed
- Thread starter Little T
- Start date
Hi Cray, are you Able to put on the fender after your relocation?
Attachments
Yes, but it takes some time to figure out the right sequence. You cannot go in order and do not tighten down each one as you go. You need to leave them loose so you have some room to get all the bolts in first. See attached photo. Try starting with that one first, as it was the most difficult for me to get in.
Attachments
Appreciated your quick response. I zip-tied the radar and put everything back together. Hopefully everything will work
Attachments
Hope it works for you too! I've been driving around for almost 2 weeks now and have not had the warning lights come back up. The only thing is that the cross traffic sensors (yellow warning arrows visible in the HUD) will likely not work anymore.Appreciated your quick response. I zip-tied the radar and put everything back together. Hopefully everything will work
Hope it works for you too! I've been driving around for almost 2 weeks now and haven't had the warning lights come back on. The only thing is that the cross traffic sensors (yellow warning arrows visible in the HUD) will likely not work anymore.
It would be the best solution as long as the Adaptive Cruise Control work
Keep us posted!
If you run into any issues - DM me.
If you run into any issues - DM me.
ARB needs to post these pictures up in their instruction manual, 'Step 83: Open package of Zip Ties -''. Great work, like the poster above, I hope this is the solution.Appreciated your quick response. I zip-tied the radar and put everything back together. Hopefully everything will work
Havent heard anything from you, did it work out?Appreciated your quick response. I zip-tied the radar and put everything back together. Hopefully everything will work
It worked for a 60-mile trip, but failed after running over a bumpy stretch of freeway.
I probably need to retie these radars.
So I’ve been putting miles on the truck but didn’t wanna comment until I felt 98% confident that it’s solved.
But after doing the relocation work I’ve yet to have any issues and feel confident that was my issue.
ARB need to make a note in the instructions to keep them pointing outwards.
But after doing the relocation work I’ve yet to have any issues and feel confident that was my issue.
ARB need to make a note in the instructions to keep them pointing outwards.
You might want to get a ADAS test done at your dealership where they measure TSS sensor height & angles. Toyota dealers & trained collision centers do it after front end collision repair or mods. Ask them about a Zero Point Calibration.
Welp spoke too soon. Had the error come back.
Similar threads
