Part# for this trim piece

[LC250CO14]

Post #11

That looks like part #5.

 

[EOD Guy]

In the 1st pic it shows a bolt that may have to be removed in order to get #6 off, IDK as I've never had that piece off.

 

[Alex_Prado]

Hi All,

I did this Nashfab install yesterday - it was pretty straightforward and I didn't break the small yellow clip - but I did find it impossible to get the clip back in. Rather than force it or damage it - I just resorted to using 3M tape to have it secured. I drove 140kmph on the highway for over 30 mins on the way home (that's the speed limit of that road in the UAE) and had no issues in it flying off or loosening - so 3M double sided tape is an option for those that don't want to break anything.

 

[handy]

Looks good.. for me the yellow clip went in easily one one side but was really hard on the other. I think I kind of smashed it in and applied super glue to it and it's been a few months now with no issues.

Until I got the Nash brackets I didn't realize how much heat was under the hood even after a short drive. I can feel the heat escaping from those vents.

 

[BigMF]

I received the part today and attached is a good view of the bottom. I just realized the small yellow clip is still attached. In the zoomed in picture the plastic hole the clip goes into looks thick on the edges, but with the naked eye it looks very skinny and fragile. I am guessing that edge piece cracked and the part then flew off. We have had a lot of high wind gusts here the last few weeks.

If you do a search of the part there are several dealers around the US that have them in stock. My local dealer didn't and they said it was on back order for 2+ months. They can also do a statewide search for you.

So, this is the "Side Seal", right? Not the "Cover Seal"? I had taken the original off a few times for running wires up to the roof and it disappeared somewhere in Alabama on my trip from Tennessee to Florida last week. Maybe @EOD Guy can find it for me.