🛠️ Member Build Front End Changes

[Brett-LC250]

Hey All! Made some changes to the front end by adding a lower bumper assembly, a Warn EVO 10S Winch with Bluetooth controller, a Rigid light bar, a super clean fairlead, and a power supply run from rear battery to the front engine bay. Completed the project over two days, and took approximately 14 hours total. Not rushing, but being thorough and super careful not to mess anything up.

Very happy with the results, and hope that others like the look too.

Loved the look on my wife's face when she seen the front end off, and asked if I knew how to put it all back together, and my typical response was "totally unsure if I can"...haha

 

[MaximusLC]

Hey! Any details on the power supply? Which route did you take and what’s size wiring?

 

[Blue Bear]

That's a great look - minimalist bumper with the winch enclosed inside. Sweet!

 

[MSINAL]

Curious if you notice any negative effect on A/C performance with winch blocking some air flow.