I have a FE. I' think I've scrolled through everything.
Can we change the default acceleration speed in cruise control? Manual says if equipped, I can't find it.
- Thread starter Buckfever
- Start date
OP
OP
- Thread starter
- #3
Can someone walk me through this I can't figure it out.
OP
OP
- Thread starter
- #4
Found it. It's under vehicle settings DRCC and then adjust.
OP
OP
- Thread starter
- #5
I also increased the curve speed reduction. And then I reset the key setting see if that keeps it at default. Way too much to figure out here it's going to take time.
Trying to figure out how to read the settings in the manual vs. the way you implement the settings in the system. My intuition says that all three bars illuminated is “high” and one bar illuminated is “low”. However, the manual is inconsistent as it sometimes lists the sequence as “High/Mid/Low” as in DRCC Acceleration setting and sometimes lists as “Low/Mid/High” as in PDA Support Sensitivity.
See screen shots below. I think I have DRCC set so that it won’t reduce speed on curves and when it does reduce speed aside from curves, it will accelerate quicker to get back up to speed. That is what I want, but it is difficult to test as I need to be at highway speeds using DRCC and I only do that once on month on road trips.
Thoughts? Should the manual always say “low/mid/high” to match the way the system actually works?
See screen shots below. I think I have DRCC set so that it won’t reduce speed on curves and when it does reduce speed aside from curves, it will accelerate quicker to get back up to speed. That is what I want, but it is difficult to test as I need to be at highway speeds using DRCC and I only do that once on month on road trips.
Thoughts? Should the manual always say “low/mid/high” to match the way the system actually works?
OP
OP
- Thread starter
- #7
For the acceleration setting I have it on one bar and the acceleration seemed more gradual today, but we'll have to test it some more.
